Bus Transceiver (Project Red)
| Bus Transceiver (Project Red) | |
|---|---|
.png)
| |
|
| |
| Name | Bus Transceiver (Project Red) |
| Source Mod | Project Red |
| ID Name | ?
|
| Type | Item |
| Stackable | Yes (64) |
The Bus Transceiver, sometimes referred to as a Bus Xcvr, is a bundled signal logic gate with 4 inputs and 2 outputs.
I/O
The Bus Transceiver has a total of 4 inputs and 2 outputs. When placed, on the ground, the left and right sides of the gate are the left and right latch inputs while the other 2 are the bundled connections. Bundled connections will only connect to Bundled Cable.
Logic
Bundled signals can run from front-to-back, or from back-to-front. These two directions are by default blocked, but the corresponding latch input can enable flow in that direction. By default, the right latch corresponds with back-to-front flow, and the left with front-to-back flow.
The 2 large display panels on each side of the gate dynamically indicate which signal is active for that side.
Configuration'
A shift-right-click with a screwdriver can flip the gate horizontally. When flipped, the gate's latch inputs will swap, at which point the right will correspond with front-to-back signal flow, while the left will correspond with back-to-front signal flow, which is opposite from its default behavior.
The gray blocks attached to each display panel indicate which latch goes with which direction of signal flow.
Any issues pertaining to "Bus Transceiver" are maintained on the ProjectRed Github page. Report issues there.
Recipe[edit]
Usage[edit]
Bus Transceiver (Project Red) has no known uses in crafting.
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
.png){kind=link}